A Bit Our Wall Art
UNPACKAGING
For Impact blocks and Collections, simply break the seals on each box and lift the product out. If your product is wrapped in protective cellophane then rip the labels that hold it together or cut the tape at the rear of the product only and remove from the open end of the bag.
​
CLEANING YOUR ARTWORK
Even though all of our printed pieces are made with fade resistant, durable, high quality, genuine Epson pigment inks, a little care is still needed when cleaning and looking after them.
What to use?
​
All you need is a dry, soft, non-fuzzy cloth such as microfibre or cotton. Lightly wipe dust from the surface. Do not rub or apply pressure as this may damage the surface.
Packages:
Table Displays
The hanging system is again integrated into the frame and will be mounted in a similar way to Wall Blocks.
​
-
Measure the distance between the hangers and use this measurement when drilling holes into the wall
-
Drill holes into the wall at your desired height
-
Place wall plugs into holes
-
Insert a screw until it is almost entirely in the wall
-
Hang the collage on the screws
Lustre Collection
As above [Blended Collection]
Blended Collection
Our collections have the same hanging design as our Impact blocks with the exception of having an additional hanging template to show you where you should position each screw.
Simply position the template on the wall where you would like your collection to be, either securing with masking tape if the surface will allow, or by two people holding it in place whilst the screw holes are marked. Lightly pop a nail into each X on the template to mark the wall ready for making the screw holes.
Remove the template then proceed as per Impact block instruction above for each screw hole.
Impact Pieces/
Acrylic
Fitting as above.
​
Cleaning:
All you need is a dry, soft, non-fuzzy cloth such as microfibre or cotton. Lightly wipe dust from the surface. Do not rub or apply pressure as this may damage the surface.
​
Impact
All our Impact blocks are fitted with saw tooth hangers and 4 supports to create a floating effect. Depending on the size of the piece, one or two hangers are attached to the back of the product.
​Hanging your picture can generally be done with screws fixed into holes in the wall using wall plugs.
​
-
Measure the distance between the hangers and use this measurement when drilling holes into the wall - if you only have 1 hanger then no need to do this, simply mark where you would like the centre point of your art work
-
Drill holes in the wall at your desired height
-
Place wall plugs into holes suitable for your wall type (if screwing into wood, plugs are not needed)
-
Screws are then fitted into the holes but leaving roughly an 1.6cm overhang to allow the artwork to hang with the supports on the back resting on the wall to give the floating effect
Salvador
This is a Job Description. Briefly describe your specific position, including details about important achievements and milestones. Make sure to include relevant skills and highlights, and don't forget to adjust the timeframe in the subtitle.
Let's Get
Social
